The brand new Wheel Horse Stables Store is now open!

You can visit it here -

This store is not being updated, there are a lot more products and discounts in the new store.

  * The step treads we use have been changed to a more aggressive material.  These are the step treads we now use on the tractors we restore.  They are a finer grit sandpaper type, high traction, anti slip, waterproof, and have an aggressive pressure-sensitive adhesive.

 The treads are 18" long, 6" wide, and will do any tractor.  If you prefer them to be shorter they are very easy to cut.

  This is the 2 piece step tread set, we offer this in a 4 piece set also if you want to do the vertical part at the rear of the step.  This is what Toro did on the 520's and it gives the tractor a more finished look while offering even more protection.   If you have a lot of rust pits on the rear of the step it helps provide a better look as well.

  The adhesive on these treads is very strong.  Make sure the step surface is clean, you can use wax + grease remover, or alcohol to make sure the surface is clean.  We recommend using a spray bottle with water and a little dish washing liquid, then covering the step as well as the back side of the tread before applying them.  Once you get them where you want them you can then use a squeegee to finish the application.  After the steps are applied you can trim the excess from the front of the step and any bolt holes if needed.

2 Piece Step Treads. 100% Made in USA.

Length -  18"
Width -    6"

 Price includes 2 - 18" x 6" step treads.

Write a review

Note: HTML is not translated!
    Bad           Good

2 Piece Step Treads

  • $7.99

Related Products

4 Piece Step Treads

4 Piece Step Treads

  * The step treads we use have been changed to a more aggressive material.  These are t..


Tags: Step, Treads